P0C36
Hybrid/EV Battery Temperature Sensor F Circuit High
P0C36 means the voltage from battery temperature sensor F sits above its valid range. With GM's NTC thermistor and pull-up, an open circuit, a broken wire or an unplugged connector pulls the input up and reads as an impossibly cold cell group. GM's 2016 table fails it below −69 °C in 8 of 10 samples, the Volt battery tables of 2016 to 2019 below −40 °C for 1.4 s within 2 s, and the eAssist table above 4.63 V, about −45 °C, in 7 of 10 samples, each as Type B, two trips. Volt bulletin 18-NA-342 lists it as sensor 6 circuit high voltage and links the F group to a Battery Too Cold message. The counterpart for a short to ground is P0C35. Expect limited power and possibly pack heating that is not needed.
Possible causes
- Open circuit or unlatched connector of sensor F high
- Thermistor F open internally medium
- Module software setting the code falsely in the cold (GM Volt) low
Symptoms
- MIL after two trips
- Battery too cold, plug in to warm message
- Reduced electric power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C36
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.