P0C35
Hybrid/EV Battery Temperature Sensor F Circuit Low
Sensor F is an NTC thermistor with a pull-up on the sensing board, so its voltage drops as temperature rises; a short to ground looks like an extremely hot cell group. Low refers to the signal, not to the temperature. GM's 2016 table sets P0C35 when the converted value exceeds 160 °C in 8 of 10 samples; the Volt battery tables of 2016 to 2019 use above 87.5 °C for 1.4 s within 2 s; the eAssist mild hybrid flags a sense voltage under 0.3 V, about 90 °C, in 7 of 10 samples. All are Type B, two trips. Volt bulletin 18-NA-342 calls it sensor 6 circuit low voltage. The opposite fault is P0C36; a pack that is really too hot is reported as P0A7E. Because the controller must assume heat, it cuts power and may run the cooling hard.
Possible causes
- Sensor F signal wire chafed and shorted to ground high
- Internally shorted thermistor F medium
- Faulty input on the battery sensing board low
Symptoms
- MIL after two trips
- Battery cooling running at high speed
- Strongly reduced charge and drive power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C35
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.