P0C34
Hybrid/EV Battery Temperature Sensor F Circuit Range/Performance
P0C34 checks whether sensor F, GM's sensor 6, agrees with the rest of the pack. The controller compares its reading with the average of the other battery temperature sensors. GM's 2016 hybrid table fails it above 25 °C difference in 50 of 67 samples; the Volt and plug-in tables of 2016 to 2019 use 20 °C, in 2018 for 5 s within 6.7 s; the air-cooled eAssist (13OBDG05C) allows only 8.55 °C and tests only after more than six hours with the module off. All are Type B, two trips. Active circuit codes suspend the test, so P0C34 means a sensor that reads wrongly but within range, or a real local hot or cold spot. Volt bulletin 18-NA-342 names it sensor 6 performance among codes that set in cold weather without a hardware fault.
Possible causes
- Sensor F drifting or poorly seated on its cell group medium
- Module software setting the code falsely in the cold (GM Volt) medium
- Real local temperature difference from a weak cell group or uneven cooling low
Symptoms
- MIL on after two trips
- Battery too cold or reduced power message
- Limited charge and discharge power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C34
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.