P0C2F
Internal Control Module Drive Motor/Generator - Engine Speed Sensor Performance
P0C2F is an internal plausibility check of the hybrid control processor: the engine speed it reads through its own sensor path must match other speed information. In GM's Two-Mode truck tables (12OBDG06, 13OBDG06) the HCP compares its SPI-sensed engine speed with the calculated transmission input speed and with the engine speed received over CAN; a deviation beyond 250 rpm above 1500 rpm, with a wider band at lower speed, in 160 of 320 samples sets it as Type A, MIL after one trip. Ford uses it on the 2021–2023 Mustang Mach-E as P0C2F:92 in the secondary OBD module C, paired with a 1 Pedal Drive fault message; bulletin 24-2187 fixes it by reprogramming the powertrain modules. Real sensor circuit faults have their own codes.
Possible causes
- Control module software flagging the comparison falsely (Ford Mach-E, fixed by reprogramming) high
- Speed signals disagree because of a faulty input or a disturbed CAN signal medium
- Internal fault of the hybrid control module low
Symptoms
- MIL or hybrid system warning
- One pedal drive or regenerative functions switched off (Ford Mach-E)
- Reduced hybrid assist or limited power
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C2F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.