P0C2E
Electric/Auxiliary Transmission Fluid Pump Control Module Feedback Signal High
P0C2E means the feedback line from the auxiliary pump control module sits above its valid range, for example shorted to supply voltage or no longer pulled down by the module. No manufacturer documents this exact code publicly. GM's use of the siblings shows what the line carries: on the Two-Mode hybrids P0C2B watches a status message from the pump controller every 1.5 s, Type B, and on the Chevrolet Bolt EV and EUV bulletin 21-NA-148 links the low variant P0C2D to bad solder joints inside the pump. A stuck-high line can hide real pump faults, so the controller usually stops relying on the pump. CARB requires circuit checks for such signals. P0C2D is the low side, P0C2C the plausibility check, P0C25 the high fault on the command line.
Possible causes
- Feedback line shorted to supply voltage high
- Output stage of the pump control module no longer switching medium
- Lost ground at the pump module letting the line float high low
Symptoms
- MIL or Service Vehicle Soon lamp
- Start-stop or electric drive restricted
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0C2E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.