P0C2B
Electric/Auxiliary Transmission Fluid Pump Control Module Feedback Signal
P0C2B concerns the status signal the auxiliary pump control module sends back to the controlling module. GM uses it on the Two-Mode hybrid trucks and SUVs (Tahoe, Yukon, Escalade, Silverado, Sierra, 2ML70): the hybrid controller expects a complete fault status message from the pump controller every 1.5 s; if it is missing or incomplete for 9.75 s with the vehicle in Run or Crank, the code sets as Type B, MIL after two trips. GM preliminary information PIP4751G stresses that P0C2B, with or without P2797, rarely means a bad pump: check the wiring, replace the pump control module if its date code is 089-11 or older, and note that a key held in Crank during a no-start can set it. P0C2C to P0C2E are the specific variants.
Possible causes
- Wiring or terminal tension fault between hybrid controller and pump control module high
- Early pump control module (GM date code 089-11 or older) medium
- Key held in crank for a long time during a no-start low
Symptoms
- MIL after two drive cycles
- Bumps, lulls or surges around auto-stops
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0C2B
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.