P0C24
Electric/Auxiliary Transmission Fluid Pump Control Module Circuit Low
P0C24 means the circuit from the controlling module to the auxiliary pump control module is held low, typically a short to ground on the command line. No manufacturer documents this exact code publicly. How the line is used is visible in Ford's 2016 F-150 2.7L bulletin, where the PCM commands the start-stop pump by duty cycle and the technician checks the pump by sweeping that command from 20 to 90 percent. A grounded line leaves the pump without a valid command or, depending on logic, permanently off. GM's ELR pump controller likewise depends on its wake-up signal to run. CARB requires output circuits of such components to be monitored. P0C23 is the open circuit, P0C25 the high side, P2796 to P2798 the classic pump control circuit codes.
Possible causes
- Command wire shorted to ground, e.g. chafed at the transmission case high
- Fluid or corrosion in the pump connector pulling the line low medium
- Output stage in the PCM/TCM or input of the pump module faulty low
Symptoms
- No engine auto-stop
- MIL or transmission warning
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P0C24
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.