OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C23

Electric/Auxiliary Transmission Fluid Pump Control Module Circuit/Open

P0C23 is set by the controlling module, usually the PCM, TCM or hybrid controller, when the circuit to the auxiliary pump control module is open. J2012 does not name the line further; in practice it is the command or enable wire. Ford's 2016 F-150 2.7L bulletin shows such a command: the PCM drives the pump with a duty cycle that a scan tool can vary from 20 to 90 percent. GM's ELR pump controller only runs its phase tests while a wake-up signal is on. No manufacturer publicly documents P0C23 itself. With the line open the pump gets no command and stays off, so auto-stop is disabled and pressure support is missing. P0C24 and P0C25 are the low and high variants, P0C2B to P0C2E the feedback line in the other direction.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 23

Possible causes

  • Open command or enable wire between controller and pump module high
  • Pushed-out or corroded terminal at the pump module or controller connector medium
  • Input stage of the pump control module faulty low

Symptoms

  • Start-stop no longer works
  • MIL or transmission warning
  • Harsh engagement after an engine stop

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P0C23

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication