OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C20

Electric/Auxiliary Transmission Fluid Pump Phase U-V-W Circuit/Open

P0C20 means at least one of the three motor phases of the auxiliary transmission fluid pump carries no current, typically an open lead, terminal or winding. GM uses it in the pump controller of the Chevrolet Volt (2011-15 tables) and the 2016 Cadillac ELR: with the inverter in Run, high voltage above 35 V and the rotor within 30 degrees of a phase axis, the peak current of that phase is checked; below 1 A for 200 counts sets the code, Type A, MIL on the first trip. Each phase is tested in turn as the rotor turns. The pump cannot build torque, so pressure support and electric operation are lost. Later GM tables split the check into the per-phase codes P0B01, P0B04 and P0B07; P0C21/P0C22 are the low and high variants.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 20

Possible causes

  • Motor connector of the pump not fully seated, or loose phase terminal high
  • Open phase lead between pump inverter and motor medium
  • Power switch of one phase in the pump inverter not conducting medium
  • Open winding in the pump motor low

Symptoms

  • MIL and Service Vehicle Soon message
  • Reduced propulsion or no electric drive mode
  • Engine restart harsh or delayed

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C20

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication