OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C1E

Electric/Auxiliary Transmission Fluid Pump Control Module Internal Temperature Sensor Circuit Low

P0C1E reports that the signal voltage of the module's internal temperature sensor is below its valid range. With the usual NTC thermistor, low voltage corresponds to a very high temperature, so a short to ground looks like an overheated board. No manufacturer documents this exact code publicly. GM shows the scale on the 2016 ELR pump controller with its own code P1E35, labelled circuit low: a reading above 130 °C, near 0 V, for 250 of 350 samples at 10.4 ms sets a Type B fault, MIL after two trips. The Honda CVT pump patent uses this board value to cut the pump relay, so a shorted sensor can stop the pump although nothing is hot. P0C1F is the high side, P0C1B a genuine overtemperature.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 1E

Possible causes

  • Board temperature sensor or its signal path shorted to ground inside the module high
  • Measuring circuit of the pump control module faulty medium
  • Fluid or moisture on the module board low

Symptoms

  • Pump switched off as if overheated, auto-stop unavailable
  • MIL after two drive cycles

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C1E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication