OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C16

Drive Motor B Inverter Phase W Over Temperature

P0C16 is set by the motor B inverter when phase W runs too hot and the temperature sensor itself shows no fault. GM's tables give PIM sensor F above 98 °C for the 2011 Volt, above 88 °C with an 85 °C reset for the 2012 two-mode trucks, and 131 °C for 1.2 s within 2 s for the 2016 Volt, with 1.5 s in the 2019 table; each is Type A, one trip. Thermistor circuit codes such as P0BE0 and P0BE1 take priority and block the check. P0C14 and P0C15 are phases U and V, P0C13 is phase W on motor A. CARB allows some protective overtemperature strategies to run without MIL, but GM lights it here. Look for weak cooling first; until then motor B is derated.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 16

Possible causes

  • Low coolant level or air in the power electronics loop high
  • Electric coolant pump of the inverter failed or blocked high
  • Dirty low-temperature radiator or inoperative fan medium

Symptoms

  • Malfunction indicator lamp after one drive
  • Reduced propulsion, notably at high load or high ambient temperature
  • Hybrid system overheat message

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C16

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication