OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C15

Drive Motor B Inverter Phase V Over Temperature

P0C15 reports overtemperature at phase V of the motor B inverter, based on a sensor reading that is valid but above the limit. GM applies it on the Volt and the two-mode trucks: PIM sensor D above 98 °C on the 2011 Volt, 88 °C on the 2012 trucks, 102.5 °C on the 2016 ELR, 131 °C for 1.2 s within 2 s on the 2016 Volt and in the 2018 table, every time Type A with one trip. It is a protective diagnosis, not a wiring check; the thermistor's own codes P0BD6 and P0BD7 handle sensor faults. Phase U and W are P0C14 and P0C16, phase V on motor A is P0C12. GM bulletin PIC6303A names P0C15 among the overheat codes that call for a cooling diagnosis. Motor B output is restricted.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 15

Possible causes

  • Coolant loss or air in the inverter cooling loop high
  • Electric coolant pump of the power electronics not working high
  • Blocked radiator for the power electronics or fan failure medium
  • Poor heat transfer or ageing power stage inside the inverter low

Symptoms

  • Malfunction indicator lamp after one drive
  • Reduced propulsion until the inverter has cooled
  • Engine runs more often than usual

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C15

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication