OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C14

Drive Motor B Inverter Phase U Over Temperature

P0C14 is the motor B counterpart of P0C11: phase U of the second inverter has become too hot while its temperature sensor reads plausibly. GM documents it on the Volt and the two-mode trucks. The 2011 Volt compares PIM sensor B with 98 °C, the 2012 trucks use 88 °C with a reset at 85 °C, the 2016 Volt 131 °C for 1.2 s in 2 s and the 2019 table 131 °C for 1.5 s, all Type A, one trip. Sensor circuit codes such as P0AF2 or P0AF3 point to the thermistor instead and are checked first. P0C15 and P0C16 cover phases V and W. GM bulletin PIC6303A sends technicians to the cooling system when inverter overheat codes appear. Power from motor B is limited meanwhile.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 14

Possible causes

  • Low coolant level or air in the power electronics cooling loop high
  • Failed electric coolant pump of the inverter loop high
  • Clogged low-temperature radiator or failed cooling fan medium
  • Long periods of high load on motor B, e.g. towing or steep climbs low

Symptoms

  • Malfunction indicator lamp after one drive
  • Reduced propulsion power, especially under load
  • Hybrid system overheat message

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C14

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication