OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C13

Drive Motor A Inverter Phase W Over Temperature

P0C13 covers phase W of the motor A inverter: the controller sees a credible sensor reading that exceeds the overtemperature limit. GM's 2011 Volt uses PIM sensor E with 98 °C, the 2012 two-mode trucks 88 °C, the 2016 and 2018 tables 126 °C for 1.2 s within a 2 s window and the 2019 table 128 °C for 1.5 s, always Type A, one trip, so the MIL comes on at once. The check is blocked while circuit or performance faults of the thermistor are active. Siblings are P0C11 for phase U and P0C12 for phase V; P0C16 is phase W on motor B. Because the code reports a real heat condition, the cooling system of the power electronics is the first place to look; output stays limited.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 13

Possible causes

  • Coolant loss or air pocket in the power electronics loop high
  • Electric coolant pump for the inverter stopped or running slow high
  • Debris on the low-temperature radiator or cooling fan not running medium

Symptoms

  • Malfunction indicator lamp immediately after the fault
  • Reduced propulsion until temperatures drop
  • Engine runs more often, little or no electric driving

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C13

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication