OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C12

Drive Motor A Inverter Phase V Over Temperature

P0C12 sets when the inverter for motor A measures an excessive temperature at phase V while its sensor itself is plausible. In GM's 2011 Volt table that is PIM sensor C above 98 °C; the two-mode trucks of 2012 use 88 °C with an 85 °C reset, the 2016 Volt 126 °C for 1.2 s out of 2 s and the 2016 ELR 102.5 °C, all Type A, one trip. The sensor circuit codes of that thermistor, such as P0BD1 and P0BD2, have their own numbers and must be ruled out first. P0C11 and P0C13 are phases U and W, P0C15 is phase V on motor B. GM bulletin PIC6303A lists these overheat codes as a sign of insufficient cooling. Power is reduced while the inverter is hot.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 12

Possible causes

  • Low coolant level or trapped air in the inverter cooling loop high
  • Inoperative electric coolant pump of the power electronics high
  • Blocked low-temperature radiator or failed cooling fan medium
  • Degraded thermal contact or failing power stage inside the inverter low

Symptoms

  • Malfunction indicator lamp after one drive
  • Propulsion power reduced, especially under load or in hot weather
  • Hybrid system overheat or service message

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C12

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication