OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0C11

Drive Motor A Inverter Phase U Over Temperature

P0C11 is a protective code: the temperature sensor at phase U of the motor A inverter reads a valid but excessive value. GM uses it across its hybrids. The 2011 Volt reads PIM sensor A against 98 °C, the 2012 two-mode trucks against 88 °C with a reset at 85 °C, both Type A; the 2016 Volt sets it above 126 °C for 1.2 s within 2 s, the 2019 table above 128 °C, Type A, one trip. On eAssist the single inverter code P0C11 sets above 118.2 °C as Type B, two trips. Sensor faults such as P0AEE block it. Phase V and W are P0C12 and P0C13. GM advises finding the cause of poor cooling. The inverter cuts power to protect itself.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberC / 11

Possible causes

  • Low coolant level or air in the power electronics cooling loop high
  • Failed or weak electric coolant pump of the inverter loop high
  • Clogged power electronics radiator or inoperative cooling fan medium
  • Sustained heavy load such as towing uphill in high ambient heat low

Symptoms

  • Malfunction indicator lamp, often with a hybrid system overheat message
  • Reduced propulsion power until the inverter cools down
  • Electric drive unavailable, engine runs continuously

Inspection / repair

  • Difficulty: hard
  • DIY: shop recommended

What Pro shows you for P0C11

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 1 affected component(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication