P0C09
Drive Motor B Phase U-V-W Circuit Low
P0C09 marks a U, V or W phase line of drive motor B that is pulled low, for example by a short to the negative high-voltage rail, to ground or by a power switch that conducts when it should not. It is the motor B twin of P0C06; the siblings P0C08 and P0C0A cover an open phase and a phase stuck high. No manufacturer documents P0C09 publicly, and GM's hybrid tables use only P0C08 for motor B phase circuits. CARB requires circuit fault monitoring of hybrid components. A low phase usually causes overcurrent too, so P0C04 or insulation codes often accompany it. The motor controller switches motor B off; the vehicle continues with reduced power and a warning lamp.
Possible causes
- Phase cable or winding of motor B shorted to ground or housing medium
- Shorted low-side power switch in the motor B inverter medium
- Insulation damage from heat, moisture or chafing low
Symptoms
- Motor B shut down with warning lamp
- Overcurrent or insulation codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0C09
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.