P0BF9
Drive Motor B Phase W Current Sensor Circuit
P0BF9 is reserved for a general circuit fault of the phase W current sensor in the drive motor B inverter, outside the offset, low and high categories that have their own codes. No manufacturer documents this exact code publicly; GM's tables from the 2011 Volt through 2019, and Jeep's 2020 Renegade and Compass PHEV bulletins, refer only to the specific siblings, chiefly P0BFA. CARB requires hybrid sensor circuits to be monitored. If the controller cannot trust phase W of motor B, it can no longer close the three-phase current balance checked by P0BFE and therefore limits or disables that motor. The sensor sits inside the inverter, so repair usually means replacing the inverter assembly.
Possible causes
- Failed phase W current sensor in the motor B inverter high
- Supply or signal fault on the inverter's sensor board medium
- Software fault in the motor B control processor low
Symptoms
- Hybrid system warning and malfunction indicator lamp
- Reduced power or no contribution from drive motor B
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BF9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.