OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BF8

Drive Motor B Phase V Current Sensor Circuit High

P0BF8 sets when the phase V current sensor of drive motor B reports more current than its valid range allows. GM uses above 800 A on the 2011 Volt with the PWM output disabled (Type A), above 700 A on the 2012 and 2013 two-mode trucks (Type B, two trips) and above 700 A for 0.05 of 0.1 s in the 2016 tables or 0.1 of 0.15 s in a 2019 table (Type A, one trip). Such a reading while the inverter is not switching, or far above the overcurrent limit, isolates a sensor-side fault such as a signal shorted to the supply or a broken reference ground. It pairs with P0BF7 for the low side and P0BF6 for offset; real overcurrent appears as P0C04. Expect motor B to be derated and further inverter codes in memory.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / F8

Possible causes

  • Failed phase V current sensor in the motor B inverter high
  • Sensor signal shorted to the sensor supply voltage or open reference ground medium
  • Poor contact at an internal or external inverter connector low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced power from drive motor B

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BF8

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication