OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BF7

Drive Motor B Phase V Current Sensor Circuit Low

P0BF7 reports that the phase V current sensor of the motor B inverter outputs a signal below its valid range. In GM's hybrid tables the converted current must fall below -800 A on the 2011 Volt (Type A, one trip), below -700 A on the 2012 and 2013 two-mode trucks (Type B, two trips, 10 of 15 samples) or below -700 A for 0.05 of 0.1 s (2016) and 0.1 of 0.15 s (2019), both Type A. Values like these are physically impossible for the motor phase, so the controller treats them as a sensor or circuit failure, for example a shorted output or a lost sensor supply. Unlike P0BF6 the sensor is not merely offset but outside its measuring range. Drive motor B then runs restricted.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / F7

Possible causes

  • Failed phase V current sensor in the motor B inverter high
  • Sensor signal or supply pulled to ground on the sensor board medium
  • Poor contact at an internal or external inverter connector low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced power or no contribution from drive motor B
  • Possible shutdown of electric drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BF7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication