P0BF4
Drive Motor B Phase U Current Sensor Circuit High
P0BF4 is the upper-limit counterpart of P0BF3 for the phase U current sensor of drive motor B. GM's thresholds: above 800 A on the 2011 Volt, checked with PWM output disabled (Type A); above 700 A on the 2012 and 2013 two-mode trucks (Type B, two trips); above 700 A for 0.05 of 0.1 s in the 2016 tables and 0.1 of 0.15 s in a 2019 table (Type A, one trip). Because the test runs with the power stage idle or the value lies far beyond any real current, it points to the sensor, its supply or an open reference rather than to genuine overcurrent; GM reports real excess phase current of motor B separately under P0C04 (above 600 A in the 2016 and 2019 tables). Motor B output is limited until repair.
Possible causes
- Failed phase U current sensor in the motor B inverter high
- Sensor signal shorted to the sensor supply voltage or open reference ground medium
- Poor contact at an internal or external inverter connector low
Symptoms
- Malfunction indicator lamp and hybrid warning
- Reduced power from drive motor B
- Further inverter or phase current codes stored
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BF4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.