OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BF3

Drive Motor B Phase U Current Sensor Circuit Low

P0BF3 is stored when the phase U current sensor of the motor B inverter reports a value below its valid range. GM converts the sensor voltage into amps and sets the code below -800 A on the 2011 Volt (Type A, 4 of 6 samples), below -700 A on the 2012 and 2013 two-mode trucks (Type B, two trips), and below -700 A for 0.05 of 0.1 s in the 2016 tables or 0.1 of 0.15 s in a 2019 table (Type A, one trip). No real phase current of motor B reaches such values, so the reading reflects an electrical defect, typically a sensor output pulled toward ground or a dead sensor. The offset check P0BF2 covers a shifted zero instead. Motor B is then restricted or shut off.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / F3

Possible causes

  • Failed phase U current sensor in the motor B inverter high
  • Sensor signal or supply pulled to ground on the sensor board medium
  • Poor contact at an internal or external inverter connector low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced power or no contribution from drive motor B
  • Possible shutdown of electric drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BF3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication