P0BF1
Drive Motor B Phase U Current Sensor Circuit
On hybrids with two electric machines, the inverter of drive motor B carries its own set of phase current sensors, which the motor control processor uses for torque control and to protect the power switches. P0BF1 is the general circuit code for the phase U sensor of motor B, meant for an electrical fault that is not classified as offset, low or high. No manufacturer documents this exact code publicly: GM's tables for the 2011 Volt, the 2012 and 2013 two-mode trucks and the 2016 to 2019 models list only P0BF2, P0BF3 and P0BF4 for this sensor. CARB requires hybrid sensor circuits to be monitored. Without a valid phase U value, motor B is usually limited or switched off.
Possible causes
- Failed phase U current sensor in the motor B inverter high
- Supply or signal fault on the inverter's sensor board medium
- Software fault in the motor B control processor low
Symptoms
- Hybrid system warning and malfunction indicator lamp
- Reduced power or no contribution from drive motor B
- Engine runs more often because electric drive is limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BF1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.