P0BED
Drive Motor A Phase W Current Sensor Circuit
P0BED is the general circuit code of the phase W current sensor in the drive motor A inverter, for an electrical fault outside the offset, low and high categories. No manufacturer documents this exact code publicly; GM's hybrid tables from the 2011 Volt to 2019, including the BAS Plus (eAssist) system, use P0BEE, P0BEF and P0BF0 instead. CARB requires hybrid sensor circuits to be monitored. Phase W matters even on systems with only two sensors: GM's eAssist table measures U and W and, if either sensor fails, runs current control in an alternate mode without the sensors. Expect reduced motor A torque, and check for related inverter codes before replacing parts.
Possible causes
- Failed phase W current sensor inside the inverter high
- Supply or signal fault on the inverter's sensor board medium
- Software fault in the motor control processor low
Symptoms
- Hybrid system warning and malfunction indicator lamp
- Reduced power or assist from drive motor A
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BED
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.