OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BEC

Drive Motor A Phase V Current Sensor Circuit High

P0BEC is set when the phase V current sensor of the motor A inverter reports a value above its valid range. In GM's tables the limit is above 700 A for 0.05 of 0.1 s (2016) or 0.1 of 0.15 s (2019), Type A; above 800 A, Type A, on the 2011 Volt with PWM output disabled; and above 700 A, Type B, two trips, on the 2012 two-mode trucks. Because the check runs while the power stage is not switching or the value is far beyond any real current, it isolates a sensor or supply fault rather than an actual overcurrent. It pairs with P0BEB for the low side and P0BEA for offset. Expect reduced drive from motor A and further inverter codes in the memory.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / EC

Possible causes

  • Failed phase V current sensor inside the inverter high
  • Sensor signal shorted to the sensor supply voltage or open reference ground medium
  • Poor contact at an internal or external inverter connector low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced power from drive motor A

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BEC

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication