P0BEB
Drive Motor A Phase V Current Sensor Circuit Low
P0BEB reports that the phase V current sensor in the motor A inverter outputs a signal below its valid range. GM compares the converted current with a lower limit: below -700 A for 0.05 of 0.1 s (2016 tables) or 0.1 of 0.15 s (2019 table), Type A, one trip; below -800 A, Type A, on the 2011 Volt; below -700 A, Type B, two trips, on the 2012 two-mode trucks. Real phase currents never reach these values, so the code points to an electrical fault such as a sensor output pulled toward ground or a dead sensor. Unlike P0BEA, the sensor is not just shifted but out of its measuring range. Motor A is then run in a restricted mode.
Possible causes
- Failed phase V current sensor inside the inverter high
- Sensor signal or supply pulled to ground on the sensor board medium
- Poor contact at an internal or external inverter connector low
Symptoms
- Malfunction indicator lamp and hybrid warning
- Reduced power from drive motor A
- Possible shutdown of electric drive
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BEB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.