P0BE9
Drive Motor A Phase V Current Sensor Circuit
P0BE9 covers a general circuit fault of the phase V current sensor in the motor A inverter, meaning an electrical problem the controller does not narrow down to an offset, low or high condition. No manufacturer documents this exact code publicly. GM's hybrid tables for the 2011 Volt, the 2012 two-mode trucks and the 2016 to 2019 models list only the specific siblings P0BEA, P0BEB and P0BEC; GM's BAS Plus (eAssist) table lists phase current codes only for U and W. CARB requires hybrid sensor circuits to be monitored. Because the three phase currents are used together for torque control and their sum is cross-checked (P0BFD), a lost V signal normally forces reduced motor A operation.
Possible causes
- Failed phase V current sensor inside the inverter high
- Supply or signal fault on the inverter's sensor board medium
- Software fault in the motor control processor low
Symptoms
- Hybrid system warning and malfunction indicator lamp
- Reduced power from drive motor A
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BE9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.