OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BE7

Drive Motor A Phase U Current Sensor Circuit Low

P0BE7 means the output of the phase U current sensor in the motor A inverter has fallen below its valid range. GM converts the sensor voltage into amps and compares it with a limit: below -700 A for 0.05 of 0.1 s in the 2016 tables and 0.1 of 0.15 s in a 2019 table, both Type A; below -700 A, Type B, on the 2012 two-mode trucks; below -440 A, Type B, two trips, in the BAS Plus (eAssist) table; the 2011 Volt uses 800 A limits for these sensors. Such values are far beyond real phase currents, so the cause is electrical, typically a sensor signal pulled toward ground. GM's eAssist controller then runs current control without the sensors, which costs motor A performance.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / E7

Possible causes

  • Failed phase U current sensor inside the inverter high
  • Sensor signal or supply pulled to ground on the sensor board medium
  • Poor contact at an internal or external inverter connector low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced power or no assist from drive motor A
  • Possible shutdown of electric drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BE7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication