OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BE5

Drive Motor A Phase U Current Sensor Circuit

The inverter of drive motor A measures the current in each motor phase with a current sensor; the controller needs these values for torque control and overcurrent protection. P0BE5 is the general circuit code for the phase U sensor, used for an electrical fault that is not classed as offset, low or high. No manufacturer documents this exact code publicly; GM's hybrid tables (2011 Volt through 2019) only use the siblings P0BE6, P0BE7 and P0BE8, and CARB requires hybrid sensor circuits to be monitored. Without a reliable phase U reading the inverter typically switches to a reduced or alternate control mode, so motor A loses power. The sensor sits inside the inverter, which usually means inverter replacement.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / E5

Possible causes

  • Failed phase U current sensor inside the inverter high
  • Supply or signal fault on the inverter's sensor board medium
  • Software fault in the motor control processor low

Symptoms

  • Hybrid system warning and malfunction indicator lamp
  • Reduced power from drive motor A
  • Possible loss of electric drive

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BE5

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication