OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BE3

Drive Motor Inverter Temperature Sensor F Circuit High

P0BE3 is the high-signal fault of inverter temperature sensor F, GM's phase W thermistor in the motor B inverter. With an NTC element and pull-up, an open circuit or a sensor that has lost ground drives the voltage up, which the controller reads as an implausibly cold inverter. GM only judges this after the inverter has worked for at least 90 s at 20 Nm or more: below -50 °C for 2.625 of 3.65 s sets Type B, two trips (2016 and 2018 tables), or Type A for 6.25 of 8.75 s (2019). The 2011 Volt uses below -58 °C (Type A), the 2012 and 2013 two-mode trucks below -40 °C (Type B). Expect limited output from motor B until the circuit is repaired.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / E3

Possible causes

  • Open thermistor or broken connection inside the power inverter module high
  • Loose or corroded connector at the inverter medium
  • Lost sensor reference ground on the sensing board low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced power from drive motor B once warmed up

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BE3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication