OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BE2

Drive Motor Inverter Temperature Sensor F Circuit Low

P0BE2 is set when the voltage from inverter temperature sensor F, the phase W thermistor in GM's motor B inverter, drops below the valid window. Because GM pairs an NTC element with a pull-up resistor, a short to ground is converted into a temperature far above anything the inverter can survive. Limits found in GM's tables: more than 170 °C for 2.5 of 3.5 s, Type B, two trips (2016 and 2018); more than 159 °C for 6.25 of 8.75 s, Type A (2019); more than 130 °C, Type A (2011 Volt); more than 125 °C, Type B (2012 and 2013 two-mode trucks). Genuine overheating of this phase has its own code, P0C16. The thermistor is part of the inverter, so it is rarely replaced on its own.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / E2

Possible causes

  • Shorted thermistor or signal line inside the power inverter module high
  • Signal shorted to ground in external wiring, where the design has any medium
  • Moisture or coolant inside the inverter housing low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Power of drive motor B strongly limited
  • Engine runs more often in hybrid operation

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BE2

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication