OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BE1

Drive Motor Inverter Temperature Sensor F Circuit Range/Performance

P0BE1 is the plausibility check of inverter temperature sensor F, GM's phase W thermistor in the motor B inverter. After the car has stood long enough, its reading must match a reference: in the 2016 and 2018 tables a calculated average after cold soak, with more than 20 °C difference for 0.525 of 0.625 s setting Type B over two trips, Type A in a 2019 table. The 2011 Volt compares against power electronics coolant temperature (20 °C, Type A), the 2012 and 2013 two-mode trucks after 360 minutes off with a 15 °C limit (Type B). GM bulletin PIC6303A lists P0BE1 for 2016-18 Volt, Malibu, LaCrosse, Velite and Regal: no customer-noticeable reaction, inverter replacement only with P0AC4.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / E1

Possible causes

  • Phase W thermistor of inverter B drifting out of tolerance medium
  • Uneven inverter cooling or residual heat after the soak period medium
  • Failing power inverter module (replace only with P0AC4 per GM PIC6303A) low

Symptoms

  • Malfunction indicator lamp after two drives, usually without drivability change
  • Code found during inspection without customer complaint

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BE1

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication