P0BE0
Drive Motor Inverter Temperature Sensor F Circuit
Sensor F is, in GM's hybrid tables, the third thermistor of the motor B inverter (inverter B sensor #3), the counterpart of sensor E in the motor A inverter; the 2016 to 2019 tables assign it to phase W. Other makers may use the letter differently. P0BE0 is its general circuit code for an electrical fault the controller does not narrow down to low, high or erratic. No manufacturer documents this exact code publicly; GM reports P0BE1, P0BE2 and P0BE3 instead. CARB requires hybrid sensor circuits to be monitored. Without a valid reading the controller cannot protect that inverter phase and usually limits the motor it drives. Read all stored codes, since inverter faults rarely come alone.
Possible causes
- Internal fault of the thermistor or its circuit inside the power inverter module high
- Corroded or loose connector at the inverter module medium
- Software fault in the motor control processor low
Symptoms
- Malfunction indicator lamp or hybrid system warning
- Reduced power from drive motor B
- Higher fuel consumption in hybrid operation
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BE0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.