OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BDE

Drive Motor Inverter Temperature Sensor E Circuit High

P0BDE means the signal of inverter temperature sensor E is above its valid range. For GM's NTC thermistor with pull-up that reads as an extremely cold phase W in the motor A inverter, typically an open circuit, lost reference ground or a failed sensor. GM sets it below -50 °C, but only after at least 90 s of inverter warm-up at 20 Nm or more, so a genuinely cold car does not trip it: 2.625 of 3.65 s, Type B, two trips, in the 2016 and 2018 tables, 6.25 of 8.75 s, Type A, in a 2019 table. The 2011 Volt uses below -58 °C (Type A), the 2012 and 2013 two-mode trucks below -40 °C (Type B). The controller usually limits power to protect the unmonitored phase.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / DE

Possible causes

  • Open thermistor or broken connection inside the power inverter module high
  • Loose or corroded connector at the inverter medium
  • Lost sensor reference ground on the sensing board low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Reduced electric drive power once the inverter has warmed up

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BDE

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication