P0BDD
Drive Motor Inverter Temperature Sensor E Circuit Low
P0BDD reports that the signal of inverter temperature sensor E, the phase W thermistor of GM's motor A inverter, sits below its valid range. GM uses an NTC thermistor with a pull-up on the sensing board, so a short to ground appears as an impossibly hot inverter. Thresholds: above 170 °C for 2.5 of 3.5 s, Type B, two trips, in the 2016 and 2018 tables; above 159 °C for 6.25 of 8.75 s, Type A, in a 2019 table; above 130 °C, Type A, on the 2011 Volt; above 125 °C, Type B, on the 2012 and 2013 two-mode trucks. A real overheat of that phase is reported separately as P0C13. With the sensor inside the inverter, the usual fix is the inverter assembly.
Possible causes
- Shorted thermistor or signal line inside the power inverter module high
- Signal shorted to ground in external wiring, where the design has any medium
- Moisture or coolant inside the inverter housing low
Symptoms
- Malfunction indicator lamp and hybrid warning
- Drive motor A power strongly limited
- Reduced regenerative braking
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BDD
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2018/18OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG01 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2011/11OBDG01 HYBRID Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2012/12OBDG06 Hybrid Diagnostics.pdf