P0BDB
Drive Motor Inverter Temperature Sensor E Circuit
Which thermistor counts as inverter temperature sensor E is set by the manufacturer. In GM's hybrid tables it is the third sensor of the motor A inverter (PIM sensor #3), assigned to phase W in the 2016 to 2019 tables. P0BDB is the general circuit code for an electrical fault that is not classed as low, high or erratic. No manufacturer documents this exact code publicly; GM uses only the siblings P0BDC, P0BDD and P0BDE. CARB requires hybrid sensor circuits to be monitored for circuit faults. Without a valid reading the controller cannot protect the phase W power switches and usually limits motor torque. The sensor is built into the inverter, so the repair is often the inverter assembly.
Possible causes
- Internal fault of the thermistor or its circuit inside the power inverter module high
- Corroded or loose connector at the inverter module medium
- Software fault in the motor control processor low
Symptoms
- Malfunction indicator lamp or hybrid system warning
- Reduced electric drive power
- Further inverter temperature codes stored at the same time
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BDB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.