P0BD9
Drive Motor Inverter Temperature Sensor D Circuit High
P0BD9 means inverter temperature sensor D delivers a voltage above its valid range. For GM's NTC sensor in the motor B inverter that equals an implausibly cold inverter, so an open circuit, a lost ground or a cracked thermistor is likely. GM checks only after the inverter has run at least 90 s at 20 Nm or more, so a real cold start is excluded. The 2016 Volt then sets it below -50 °C for 2.6 of 3.65 s, Type B, two trips; a 2019 table uses -50 °C with Type A; the 2011 Volt below -58 °C, Type A; the 2012 table below -40 °C, two trips. Until the value is valid the controller uses substitute values and may limit motor B. Check the inverter connectors before replacing the unit.
Possible causes
- Open sensor or circuit inside the power inverter module high
- Loose, corroded or unplugged connector at the inverter medium
- Lost sensor ground low
Symptoms
- Malfunction indicator lamp, depending on model after two trips
- Reduced motor B power and regeneration
- Implausibly low inverter temperature in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BD9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.