P0BD8
Drive Motor Inverter Temperature Sensor D Circuit Low
P0BD8 means the signal of inverter temperature sensor D is below its valid range; with an NTC thermistor and pull-up that reads as an extremely hot inverter, usually from a short to ground or an internal sensor fault. GM sets it above 170 °C for 2.5 of 3.5 s, Type B, two trips, on the 2016 Volt, above 159 °C, Type A, in a 2019 table, above 130 °C, Type A, on the 2011 Volt and above 125 °C, two trips, in the 2012 table. Stellantis lists P0BD8-11 for the 2026 Jeep Compass 1.6 PHEV outside the US among the codes behind a no-start with the message Electric Traction System Fault; the repair is the traction inverter of the hybrid dual-clutch transmission.
Possible causes
- Shorted sensor or circuit inside the inverter (Jeep Compass PHEV bulletin) high
- Sensor signal shorted to ground in external wiring, where present medium
- Moisture or coolant inside the inverter housing low
Symptoms
- Malfunction indicator lamp and hybrid warning
- Vehicle does not start, Electric Traction System Fault (Jeep)
- Electric drive power strongly limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BD8
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- static.nhtsa.gov/odi/tsbs/2026/MC-11033877-0001.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG01 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG01 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2011/11OBDG01 HYBRID Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2012/12OBDG06 Hybrid Diagnostics.pdf