P0BD6
Drive Motor Inverter Temperature Sensor D Circuit
Sensor D is, in GM's hybrid tables, the second thermistor of the motor B inverter, the counterpart of sensor C in the motor A inverter: phase V in the 2016 to 2019 tables, temperature sensor 2 of inverter B on the Volt. Other makers assign the letter differently. P0BD6 is its general circuit code for an electrical fault that the controller does not narrow down to low, high or erratic. No manufacturer documents this exact code publicly; GM reports P0BD7, P0BD8 and P0BD9 instead. CARB requires monitoring of hybrid sensor circuits. Without a valid value the controller cannot protect that inverter and usually limits the motor it drives. Read all stored codes, since several inverter codes often appear together.
Possible causes
- Internal fault of the sensor inside the power inverter module high
- Corroded or loose connector at the inverter module medium
- Software fault in the motor control processor low
Symptoms
- Hybrid system warning or check engine lamp
- Reduced electric drive or generator power
- Higher fuel consumption in hybrid operation
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BD6
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.