P0BD5
Drive Motor Inverter Temperature Sensor C Circuit Intermittent/Erratic
P0BD5 is meant for an inverter temperature sensor C signal that jumps or drops out for short moments. Because the heat sink of a liquid-cooled inverter changes temperature smoothly, sudden steps point to a contact fault or to interference; a Hitachi patent explains that the small thermistor signal can pick up noise from the high-voltage main circuit. No manufacturer documents this exact code publicly; GM covers its sensor C, the phase V sensor of the motor A inverter, only with P0BD2, P0BD3 and P0BD4. CARB requires hybrid sensor inputs to be monitored for erratic faults too. Freeze-frame data and a careful check of the inverter connector are the best starting points.
Possible causes
- Loose or corroded contact at the inverter module high
- Intermittent fault inside the power inverter module medium
- Interference from the high-voltage circuit on the sensor signal low
Symptoms
- Warning lamp that comes and goes
- Brief power reductions while driving
- Jumping inverter temperature in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BD5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.