OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BD4

Drive Motor Inverter Temperature Sensor C Circuit High

P0BD4 reports a voltage from inverter temperature sensor C above its valid range. For GM's NTC sensor this is an implausibly cold inverter, typically caused by an open circuit, a lost ground or a cracked element. To avoid false alarms on a cold day GM waits until the inverter has run at least 90 s at 20 Nm or more. The 2016 Volt and a 2018 table then set it below -50 °C for 2.6 of 3.65 s, Type B, two trips; a 2019 table uses -50 °C with Type A. The 2011 Volt and 2016 ELR use below -58 °C, Type A; the 2012 and 2013 tables below -40 °C, two trips. Until the reading is valid the controller protects the inverter with substitute values and may cut motor power.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / D4

Possible causes

  • Open sensor or circuit inside the power inverter module high
  • Loose, corroded or unplugged connector at the inverter medium
  • Lost sensor ground low

Symptoms

  • Malfunction indicator lamp, depending on model after two trips
  • Reduced electric drive power
  • Implausibly low inverter temperature in live data

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BD4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication