OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BD3

Drive Motor Inverter Temperature Sensor C Circuit Low

P0BD3 means the signal of inverter temperature sensor C, the phase V sensor of GM's motor A inverter, is below its valid range. GM uses an NTC thermistor with a pull-up on the sensing board, so a short to ground reads as an impossibly hot inverter. GM's thresholds: above 170 °C for 2.5 of 3.5 s, Type B, two trips, on the 2016 Volt and in a 2018 table; above 159 °C for 6.25 of 8.75 s, Type A, in a 2019 table; above 130 °C, Type A, on the 2011 Volt and 2016 ELR; above 125 °C, two trips, in the 2012 and 2013 tables. A genuine overheat of that phase is reported as P0C12. Since the sensor is part of the inverter, the usual fix is the inverter assembly.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / D3

Possible causes

  • Shorted sensor or circuit inside the power inverter module high
  • Sensor signal shorted to ground in external wiring, where present medium
  • Moisture or coolant inside the inverter housing low

Symptoms

  • Malfunction indicator lamp and hybrid warning
  • Drive motor power strongly limited
  • Reduced regeneration

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BD3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication