P0BD1
Drive Motor Inverter Temperature Sensor C Circuit
Which thermistor is called sensor C depends on the maker. In GM's hybrid tables it is the second sensor of the motor A inverter: the phase V sensor in the 2016 to 2019 tables, labelled temperature sensor 2 in the Volt and ELR. P0BD1 is its general circuit code for an electrical fault that is not classified as low, high or erratic. No manufacturer documents this exact code publicly; GM reports only the specific siblings P0BD2, P0BD3 and P0BD4. CARB requires hybrid sensor circuits to be monitored. Without a valid value the controller cannot protect that phase and normally limits motor torque. The sensor sits inside the inverter, so repairs often mean replacing the assembly.
Possible causes
- Internal fault of the sensor inside the power inverter module high
- Corroded or loose connector at the inverter module medium
- Software fault in the motor control processor low
Symptoms
- Hybrid system warning or check engine lamp
- Reduced electric drive power
- Possible loss of electric drive
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BD1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.