P0BD0
Generator Inverter Temperature Sensor A Circuit Intermittent/Erratic
P0BD0 is reserved for a generator inverter temperature sensor A signal that jumps or briefly drops out instead of failing for good. A liquid-cooled inverter changes temperature slowly, so sudden steps point to a contact problem or to interference: a Hitachi patent on inverter systems explains that the small sensor signal can pick up noise from the high-voltage main circuit and has to be filtered statistically. No manufacturer documents P0BD0 itself publicly; CARB requires hybrid sensor inputs to be checked for such faults as well. Permanent faults are reported as P0BCE or P0BCF. Freeze-frame data and a wiggle test at the inverter connector help find the cause.
Possible causes
- Loose or corroded contact at the inverter connector high
- Intermittent fault inside the inverter assembly medium
- Interference from the high-voltage circuit on the sensor signal low
Symptoms
- Warning lamp that comes and goes
- Brief drops in generator or hybrid power
- Jumping inverter temperature in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BD0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.