P0BCF
Generator Inverter Temperature Sensor A Circuit High
P0BCF reports a signal from generator inverter temperature sensor A above its valid range. With the usual NTC thermistor and pull-up, an open circuit, a lost sensor ground or a cracked element drives the voltage up, which reads as an extremely cold inverter. GM's comparable drive motor checks set below -40 to -58 °C and wait until the inverter has worked for about 90 s at 20 Nm or more, so a genuinely cold start does not trigger them. No manufacturer documents P0BCF itself publicly; CARB requires circuit monitoring of hybrid sensor inputs. Until the value is valid the controller uses conservative substitutes and may limit generator power. Check the inverter connectors before replacing the unit.
Possible causes
- Open sensor or circuit inside the inverter assembly high
- Loose, corroded or unplugged connector at the inverter medium
- Lost sensor ground low
Symptoms
- Malfunction indicator lamp and hybrid warning
- Reduced generator output
- Implausibly low inverter temperature in live data
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BCF
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.