P0BCE
Generator Inverter Temperature Sensor A Circuit Low
P0BCE means the signal of generator inverter temperature sensor A is below its valid range. Inverter thermistors are usually NTC types with a pull-up resistor, as GM's tables describe for the drive motor inverter sensors: a short to ground or a shorted element pulls the voltage down, which the controller reads as an impossibly hot inverter. GM sets the comparable drive motor codes at roughly 125 to 170 °C, depending on generation. No manufacturer documents P0BCE itself publicly; CARB requires this circuit monitoring for hybrid sensor inputs. The controller then protects the generator inverter with a substitute value and limits generator power. A real overheat is reported separately as P0A3E.
Possible causes
- Shorted sensor or circuit inside the inverter assembly high
- Signal shorted to ground in external wiring, where present medium
- Moisture or coolant inside the inverter housing low
Symptoms
- Malfunction indicator lamp and hybrid warning
- Generator power strongly limited
- Battery charge drops, engine runs more
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BCE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.