P0BCC
Generator Inverter Temperature Sensor A Circuit
In a two-machine hybrid one inverter feeds the traction motor and a second one the generator, the machine that is mainly driven by the engine to charge the battery or start it. Its power switches carry thermistors so the controller can cut current before they overheat. P0BCC is the general circuit code for sensor A of that generator inverter, used for an electrical fault the controller does not classify as low, high or erratic. No manufacturer documents this exact code publicly; CARB requires hybrid components and their sensor inputs to be monitored for circuit faults. Without a valid reading the controller limits generator power, which can reduce charging and hybrid performance. The sensor normally sits inside the inverter assembly.
Possible causes
- Fault of the sensor or its circuit inside the inverter assembly high
- Loose or corroded connector at the inverter medium
- Software fault in the inverter or hybrid control module low
Symptoms
- Hybrid system warning or check engine lamp
- Reduced generator output and battery charging
- Engine runs more often or hybrid mode limited
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BCC
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.