P0BC5
Hybrid/EV Battery Temperature Sensor E Circuit High
P0BC5 reports that battery temperature sensor E delivers a voltage above its valid range. With GM's NTC sensors that reads as extreme cold, pointing to an open wire, a backed-out pin at the sensing board or a cracked thermistor. GM's 2016 table sets it below -69 °C in 8 of 10 samples, the 2011 Volt table and GM's 2019 battery module table below -40 °C for 1.4 s within 2 s, and the eAssist mild hybrid above 4.63 V, about -45 °C, in 7 of 10 samples; all Type B, two trips. On the Chevrolet Volt, bulletin 18-NA-342 links these codes to a Battery Too Cold message at ambient temperatures above -25 °C and prescribes reprogramming. Its counterpart is P0BC4. A pack the controller believes frozen gets strict charge and power limits.
Possible causes
- Open sensor E wire or backed-out pin at the sensing board high
- Cracked or open thermistor E medium
- Module software misreading in the cold (GM Volt, reprogramming) low
Symptoms
- MIL on after two trips
- Battery too cold, plug in to warm message
- Very limited power or charging
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BC5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- gsi.ext.gm.com/gmspo/mode6/pdf/2016/16OBDG02 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2011/11OBDG01 HYBRID Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2019/19OBDG01 Hybrid Diagnostics.pdf
- gsi.ext.gm.com/gmspo/mode6/pdf/2013/13OBDG05C Hybrid Diagnostics.pdf
- static.nhtsa.gov/odi/tsbs/2018/MC-10155116-9999.pdf