OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P0BC4

Hybrid/EV Battery Temperature Sensor E Circuit Low

Sensor E is an NTC thermistor with a pull-up resistor, so its voltage falls as it gets hotter; a short to ground therefore looks like an extremely hot cell group. GM's 2016 table sets P0BC4 when the converted value exceeds 160 °C in 8 of 10 samples; the 2011 Volt table and GM's 2019 battery module table use above 87.5 °C for 1.4 s within 2 s; the eAssist mild hybrid flags a sense voltage under 0.3 V, about 90 °C, in 7 of 10 samples. All are Type B, two trips. Volt bulletin 18-NA-342 names it sensor 5 circuit low voltage. Its counterpart is P0BC5 (open circuit, reads very cold); a genuinely overheated pack is reported as P0A7E. Because the controller must assume heat, it cuts charge and discharge power and may run cooling at full speed.

SystemPowertrain
Typegeneric / SAE
GroupP0
Range / numberB / C4

Possible causes

  • Sensor E signal wire shorted to ground inside the pack high
  • Internally shorted thermistor E medium
  • Moisture or contamination on the sensing board low

Symptoms

  • MIL on after two trips
  • Implausibly high temperature for sensor E on the scan tool
  • Reduced power and battery fan or cooling at full speed

Inspection / repair

  • Difficulty: shop only
  • DIY: shop recommended

What Pro shows you for P0BC4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 4 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication