P0BC2
Hybrid/EV Battery Temperature Sensor E Circuit
Battery temperature sensor E is the fifth thermistor in the high-voltage pack; GM's Chevrolet Volt bulletin 18-NA-342 lists the E codes as temperature sensor 5 of nine. P0BC2 is the general circuit code, used when the controller detects an electrical fault without classing it as low, high or erratic. GM's hybrid tables report only the specific siblings P0BC3 to P0BC6. NHTSA's summary of an Audi pending service solution for 2027 Q6 and A6 e-tron models names P0BC2 with a failure type byte among implausible temperature sensor errors. CARB requires battery temperature sensors to be monitored for circuit faults. With one value missing the controller limits charge and discharge power. The sensor sits inside the pack, so checks call for high-voltage safety procedures.
Possible causes
- Loose or corroded connector of sensor E at the sensing board high
- Failed thermistor E medium
- Faulty input on the battery sensing board or module low
Symptoms
- Hybrid or EV system warning and MIL
- Reduced power or charging rate
- Battery cooling running more than usual
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P0BC2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.